The 2 screws are not symmetrically angledâŠ![]()
![]()
Because itâs taken from that angle ![]()
They kidnapped Deepfreeze ![]()
![]()
![]()
![]()
Thatâs why the Torx screw head is betterâŠ
You can see it there tooâŠ![]()
maybe the rivet ![]()
Small screw head protective cap?
Morning build at work. Hellvape Helheim RDTA, SS316L wire, 10 wraps on a 3mm inner diameter in dual coil configuration, resulting in 0.25ohm. Cotton Bacon wicking, cut at the bottom of the deck, just fluffed. Filled with A&L Alucard at a 70VG/30PG ratio. Iâm happy to receive comments and advice, as Iâm still a beginner. ![]()
I think you can also mix Alucard at 69/31, otherwise everything else is perfect. ![]()
![]()
Thanks ![]()
Brave ⊠![]()
![]()
![]()
You are right, I wrote the ratio incorrectly, Iâve corrected it. I always write
I thought so, I was just kidding⊠![]()
20ml Bombo Cookie Supra⊠This was either caused by the Dani power boost, or the BP Mods cotton is of lower quality compared to Bacon Prime⊠weâll know within weeks⊠power boost off⊠![]()
I think this is due to the bonbon, not the boost, but Iâm eagerly awaiting what you experience. Does it last longer without boost
Yes, Bombo gunked up a bit, but before that, 40ml went through it without leaving half as much residue behind. It wasnât used with a power boost, plus it had Bacon Prime in it, so I suspect these two. If this happens after 5 tanks without boost, then bp mods will be to blame.
Hi!
I think for the Voopoo PnP-C1, PNP-TR1, or Nautilus
Here is a similar one, and two types of mesh too.
Tonight, coil building was underway here in the cubicle. 3 atomizers received new coils.
Oxva arbiter 2, hellvape dead rabbit solo, and the steampipes corona v6. For the latter, with Kanthal A1 29ga plain wire, 2.5mm ID, 6 wraps, 1.42 ohm, 11 watts, coilology ezpz cotton.
And I started the tobacco extract liquid mixed 3 weeks ago, La tabaccheria hellâs mixture noâ 759. It turned out really delicious. ![]()
It had an original ashtray-like flavor..









