[HALADÓ] 3. rész: Vatta és vatta. Van különbség!

Én se onnan vettem ki… :rofl: :rofl:

3 Likes

Pinkman-hez? :roll_eyes::grin:

4 Likes

Ez magas labda. :joy: Jó, hogy nem én írtam. :blush:

5 Likes

Ismét egy remek írás, köszönöm Akkor, ha jól értelmezem, van külön vatta mtl-re,dl-re?Honnan tudom, hogy melyiket vegyem mtl-re?

2 Likes

Köszönöm! :hugs: Az MTL vatta lazább szerkezetű, a Vapefly Cotton Cloud’s is ilyen. Csak úgy ránézésre nem igazán lehet megállapítani, inkább tapintásra, meg persze vattázás közben látjuk, hogy mennyire tömör. A BP Mods vatta csak picivel tömörebb, az RDL-be is kiváló. DL-re meg vannak a tömör vatták, mint pl. a Kendo.

3 Likes

Köszönöm,majd azt fogom keresni.

4 Likes

Hello everyone.

I have 3 types of cotton.

I put the included coil and cotton in the Brunhilde 103 dl, then after 2-3 weeks of half-day use, I switched to UD cotton. Well, it had a terrible cotton taste, so I used up the second original cotton as well. My question is, how do these differ from each other? Aren’t they all for this purpose?

6 Likes

Hi!
Did you take off the outer layer from the UD?
Cotton clouds should be good in it, IMHO.
:face_with_raised_eyebrow: :face_in_clouds: :saluting_face:

6 Likes

I consider Cotton Clouds to be one of the best cottons!! I use it a lot!! I haven’t used UD!!

6 Likes

Of course I took it off.

7 Likes

Each has a different break-in time. Cotton Clouds delivers flavor almost immediately, I don’t know about the stock cotton, but apparently, it does too. UD, on the other hand, is plain Japanese Muji cotton, which breaks in after about half a tank. I never really liked it…

6 Likes

Thank you very much for the info, then the ud remains for the dwarv mtl, it’s flawless for that.

One more question… the coils they sent with Brüncivel are about 5mm, but Cotton Clouds, as I saw online, are good for 3mm coils, so they are still usable in it, right?

5 Likes

I think there isn’t a 5mm coil, it’s usually a maximum of 3.5mm. You need to try it on; if it’s very loose, don’t use it for that.

7 Likes

Hi,
the question wasn’t directed at me, but I would put a 3 mm coil in it and pull the Cotton Clouds into it. That should work well. :slightly_smiling_face:

Or perhaps is the 5 mm meant to be 2 x 2.5 mm coils? Because then you could use the cotton by taking minimal amounts from it - if at all - in case of double coils. Because as it is, you are thinking correctly, the Cotton Clouds is marked as 3

3 Likes

Now it has its match in it, though I didn’t measure, I just guessed. I will try to fit it in later. Thank you.

5 Likes

Just one more thing, is the photo you attached showing the factory-supplied coil? Because it says on it that its inner diameter (Diameter) is 3 mm and 0.35 ohm. So no worries, as Cotton Clouds fits perfectly. :slightly_smiling_face: (If you still have it.)

7 Likes

Yes, it’s still as in the picture, this arrived with Brüncivel, which is visible in the bottom picture.

The other 2 wicks are older.

However, then one more question… (I’ll be Calambo :rofl:)

Where can I buy Cotton Clouds wicks?

6 Likes

I sent a private message. :slightly_smiling_face:

6 Likes