Hello everyone. An incident occurred where, after I tried to change the coil in my e-cig, it started making a very nasty sound and spitting liquid as well. (Geekvape Aegis Legend 3, and the coil is a Z series KA1 0.25 ohm coil usable up to 45-57w.) I would like to ask for help regarding exactly what the problem might be, because I have tried everything, but nothing works. Thank you in advance.
5 Likes
Hello!
Welcome among us.
If I were you, I would disassemble and reassemble it again.
That 25 Ohm is a lot, in my opinion.
You should also try the tank on another mod.
A picture would help.
:saluting
8 Likes
Hi. I can say with 89% probability that the atomizer is factory defective. Likely there is too little cotton in it.
9% is that you filled the tank full and the air pressure inside pushes the liquid where it goes easiest. At the cotton.
If the spitting stopped, it’s likely the latter. If not, then a new atomizer.
2% is using a higher wattage than you are currently using.
8 Likes
0.25 Ohm
9 Likes
Yeah, I know, but still!
8 Likes
That which grasps everything and was good for everything answered… I am Groot.
6 Likes
7 Likes
Hi, it sometimes happens that factory coils are faulty. Fortunately, it’s not a common occurrence, but then they need to be replaced.
Did you not drop it, or did the tank hit something? Because I’ve had this happen several times and it wouldn’t work properly. It doesn’t take much for it; it’s enough if it’s just slightly misaligned somewhere. At such times, all parts need to be properly pressed together and tried again.
7 Likes