The Themis resurfaced after many years. I rewicked it 3 times until the dry hit stopped. 
Well, I have no idea how the coil became 0.80 ohms by morning. 
It fits Kriemhild quite well.
Good morning and have a nice day everyone! 
16 Likes
What wire did you coil it with? If it is TC-capable, e.g., SS316, then perhaps the mod measured it while hot yesterday, and this morning it is already showing the cold resistance. Assuming the resistance was higher yesterday.
5 Likes
Yesterday it was lower. 0.45, if I remember correctly.
This is supposedly a prerolled tiger coil. Demon killer. It’s definitely written on the box, but I can’t quite recall the material right now. The mod itself knows the TC.
I’ll look up a manual now, because otherwise you can play around with the resistance by ±10 in the settings too. It just occurred to me today. This is new to me
6 Likes
Hi, what liquid is this?
5 Likes
Heyoo. This is Ragnar from the wonderful szolúb (szolúb) family. Mixed at 17% as suggested by the guys. This way it also has a bit of color!
9 Likes
Ja, ok. So you put it in this glass.
Interesting, I haven’t seen anything like this before.
8 Likes
I bought it a few years ago in some webshop. Unfortunately, I don’t remember which one. 
8 Likes
I looked it up online, but it doesn’t say anywhere what material the wire is made of. 
4 Likes
I already found the 30 and 60 ml ones. I really got the chills from it.
But if I find something girly, I might jump on it, because I like the idea.
7 Likes
I don’t know if there’s still any, but Temu showed me similar things.
5 Likes
This black is quite EU-like.
5 Likes
I don’t know where you bought it, but for example, 2F says this
So, in other words, our cheap Chinese friend wrapped it with whatever wire he could get his hands on 
7 Likes
My mistake, that was a wrong assumption. I thought yesterday it showed slightly higher, e.g., dropped from 0.95 to 0.8, which could be a bad TC config (it registered the hot wire resistance). But if it jumps by such a large margin, then firstly, the coil might not be properly secured in the deck (but not overtightened), or the tank has loosened. If the airflow and/or juice flow is adjustable by turning a ring, I have also experienced the tank loosening slightly on the mod. Grasp the bottom of the deck, loosen it slightly then tighten it again (but don’t overtighten because it might get stuck); maybe that’s the only issue.
6 Likes
I was thinking something similar too. 
Then I have to figure out which is which.
6 Likes
I’ll check afterwards. It should be properly installed. I tugged it after installation. And the coil too
7 Likes
Still, an Emo perfume leftover from Easter isn’t sure to deliver the flavors…
8 Likes
Are you emo because of a skull design? XD
6 Likes
Searching for rationality in a joke… In that case, I apologize.
5 Likes
Monday afternoon final push into misery 
My mood isn’t great, the rta is fucking 2 years old 
he says NEW
13 Likes
