My mistake, that was a wrong assumption. I thought yesterday it showed slightly higher, e.g., dropped from 0.95 to 0.8, which could be a bad TC config (it registered the hot wire resistance). But if it jumps by such a large margin, then firstly, the coil might not be properly secured in the deck (but not overtightened), or the tank has loosened. If the airflow and/or juice flow is adjustable by turning a ring, I have also experienced the tank loosening slightly on the mod. Grasp the bottom of the deck, loosen it slightly then tighten it again (but don’t overtighten because it might get stuck); maybe that’s the only issue.
6 Likes