It comes with 1.0, 1.5, 2.0, and 2.2 airpins… the 2.2 one is screwed in from the factory,
I swapped it for the 1.5, but I felt it was too restrictive even with the airflow fully open. Finally, the 2.0 went in, and with the air slightly restricted, the TH appeared… although I positioned the coil very low, so there is still room to maximize the TH.
Meanwhile, I am monitoring the puff count corresponding to 1500mAh at 0.6Ohm at 18 Watts.
Things are shaping up 
It’s already certain that even those who like tight MTL won’t have complaints about the 1.0 air pin… for me, even the 1.5 is a bit forehead-furrowing 
The first build turned out leak-free and dry-hit-free… thus beginner-friendly.
100VG base with 3.6mg nicotine is flowing in it. It also delivers the flavor of pipe tobacco, just like B80. That’s all for now.
Oh, and there is NO condensation so far 
8 Likes