Exhaust outlet for smoking rooms?
7 Likes
Due to the district heating pressure regulation
4 Likes
I haven’t even vaped with district heating yet… 
2 Likes
(the rest are on vacation now, or in the wash 
Are all the liquids in the wash? 
4 Likes
Va..Sy.. SE Rda/Daniel.. 
12 Likes
Kalibr 23.30 rta, Lanskov crackle 2core alien Ni80 2.5mm ID, 5 wraps, 0.4ohm, a bit of Vape District cotton with the Scottish roll “in my own version” technique.
Corrected! Scottish roll. I pull the cotton apart loosely, as much as needed, then I roll it up loosely and then I still roll it loosely with my palm.
12 Likes
It needs a bit more cocoa!!
5 Likes
Fresh batch! If the cotton is still breaking in, it might need a little more! Though cocoa doesn’t really suit apple pie! Cinnamon is better!
5 Likes
Hi 
,
Still awesome. 
Which air pin did you choose and at what wattage is it comfortable?
5 Likes
I installed it with the 3mm air pin and the largest air disk opening. It’s good at 24-25W with this build. I didn’t let the cotton reach the bottom of the juice channel, because I’ve noticed it often just hinders the liquid flow, barely dipping into the wicking ports.
7 Likes
Same old boring for years? loyal crew. (They’ve never let me down or left me in the lurch…)
One of my old decks had to be repaired, its swivel action is too loose now.
(The system is above optimal temperature, but it's still holding up).
[grid]
8 Likes
Planting trees won’t be a problem in the garden, as long as one has enough saplings to fill every hole. 
3 Likes
Experimenting with substituting these nice Ni80 fused claptons (unfortunately, after a year and a half, it turned out I have a mild allergy). In terms of flavor, we’ve finally arrived at what I expect. I hope there won’t be any issue with 316L, because with Kanthal I’ve only managed to bring out a metallic taste so far, but from any flavor xD
8 Likes
Hi, that didn’t work for me either because it also contains nickel.
However, SS 430 does I haven’t had any allergic symptoms since then, although I’ve only been using these wires for a few years now.
8 Likes
Hi, Thank you very much for the good advice. 
I read that there can be problems with 316L too. It also contains about 10% Ni. After I hit a dead end with Kanthal, I had to try something. However, I didn’t know that ss430 doesn’t contain nickel. I guess there isn’t much difference in their behavior. At most, if I’m not mistaken, the 430 will gunk up faster. In the absence of nickel, it should theoretically be less corrosion-resistant.
6 Likes
Only KA1 and SS 430 wire, the others caused breakouts, facial redness, or itching after only 3-4 puffs. For 6-7 years, I’ve had no problems, so I no longer try other wires.
Gladly 
7 Likes
