Rékli
libatepi the best![]()
Kettőt tudnék mutatni élőben,de nincs kedvem kimenni![]()
Az enyémek amúgyis ludak ![]()
![]()
![]()
Márton és Delilah ![]()
Csere likvidre? ![]()
Szerk: Brünhilde is lehetne a nőstény lúd. Vagymi. Ontopic maradtam, hejj ![]()
Na ezt ki gugliztam![]()
![]()
![]()
A mája mindkettőnek jó lehet, akár liba akár lúd ![]()
![]()
![]()
Semmire ! A ház tartozékai ![]()
Beépítetted? ![]()
Ok, meggyőztél.
(2 likvid?)
Üzemelnek,működnek,fújnak vagy mi
messziről etetem őket
még kicsik,6-7 hónaposak a derekamig érnek ![]()
![]()
![]()
Ok, ha meggondolod, úgyis tankolni kell, mert venni kéne cukrot ![]()
Legalább nem fújnak a füledbe. ![]()
Mission: impossible. ![]()
Na kérem.Az összes Brunhilde témát végigolvasva neki kezdtem az építkezésnek.Azt a coilt vettem amit irtatok (Vandy Vape Superfine MTL Fused Clapton Ni80 - 30GA) úgy tekertem,meneteztem ahogy írtátok (kicsit hézagosan,6 menettel) 2,1mm AFC-vel.Talán annyi eltérés van hogy én BP Mods vattát használok,és jelenleg úgy néz ki a dolog hogy 17watton 0.87Ohm-ot sikerült elérnem,minimális topcap melegedéssel,szép gőzök,és nagyon finom ízek.Mindenkinek nagyon szépen köszönöm a segítséget.
Greetings.
The lady finally arrived after 2 months!
I will use it for MTL.
What do you advise? What should I watch out for, experiences, etc.?
Unfortunately, I must disappoint you, this is indeed a DL tank.
Hi!! What should you watch out for? Ultimately, just that your next order is the Brunhilde mtl rta if you want to use it for MTL!! ![]()
Be careful not to put it on a Pico, because it will tip over. This really is a DL tank. Some people adore it, some people hate it. I haven’t had one like this, but I know that this coil setup drove me crazy. Not to mention, I definitely wouldn’t put such a big tower on any of my mods. I hope you’ll have luck with it. Happy vaping! ![]()
Even if I just look at the factory winding…….rock hard dl if that helps…….
Is there anyone else here who MTLs from DL tanks… ![]()
My colleague uses a dvarw dl with a micro coil around 1.2 ohms and vapes it at ten-something watts. He is completely satisfied with it. ![]()
Even so, there are those who think that if they narrow the air, it will be MTL, but it should also be the atomizer chamber and the chimney’s inner diameter.
Next time, choose something like this for MTL use.
Magnified, you can see they are from 0.9-2.5 mm for airflow pins.

